An infant can suffocate if its head or body becomes wedged between the mattress and the crib sides.Ĥ. If you can fit more than two fingers between the edge of the mattress and crib side, the mattress is too small. Never use a crib with broken or missing parts.ģ. On cribs where the mattress support is suspended by hangers attached to hooks on the end panels, check frequently to be sure they have not become disconnected. Any screw inserted into a wood component that cannot be tightened securely should be replaced by one that fits. Make sure all screws or bolts are securely tightened. Check the crib and replace any missing parts, such as screws, bolts or mattress support hangers, before placing your child in it. Check the labeling on these products to make sure they meet safety requirements.Ģ.

Use a crib that meets Federal safety regulations and industry voluntary standards (ASTM) and make sure it has a tight fitting mattress. The plastic film may cling to a baby’s face and cause suffocation. Never use plastic bags as mattress covers. Remove and destroy all plastic wrapping materials. Use the bumpers until the baby can pull up to a standing position, then remove them so that the baby will not use them to try to climb out of the crib.Ĥ.

To prevent your baby from becoming entangled in the ties, trim off excess length after tying. Bumper pads, if used, should (a) fit around the entire crib, (b) tie or snap into place, and (c) have straps or ties at least in each corner, in the middle of each long side, and on both the top and the bottom edges.

Crib with 1 board on bottom